LoweproHardside CS 20 Case for Small Point-and-Shoot Cameras & Accessories, Black

typical lowepro quality; would buy again if it were on sale.

Fits my Leica Q3 perfectly.

Just barely fits the Panasonic ZS200, with the corners of the camera lightly pressing into the case. Very sturdy design, and looks nice. The belt loop is sewn too tight and will be hard to use. As others have stated the zipper pulls run into the fabric retainers that keeps the clamshell from opening all the way. If I did it over again I would just buy the Ruggard HFV-260 which isn't much bigger, is fairly sturdy, and provides more interior space due to being a boxy design as opposed to the tapered design of this Lowepro case.

A case for just the camera body was surprisingly difficult to find and the one from another manufacturer that was discussed in photography forums was discontinued so I did a lot of searching to find this one. This kind of body-only case was described as the holy grail :-)It fits my new-to-me used Canon 5D Mark IV almost perfectly. As you see in the second photo, the top of the camera where the hot shoe is does push out a little (as in the right of the photo). Given that my use is to put the camera body in this case then put the case in my daypack while on treks, I am not worried about the tightness there since the case has a cushion around the zipper that will prevent it from scratching the camera body. Also, the 5D does not have a flash built-in so i don't need to worry about a flash pop-up being damaged.The case is plenty wide enough to get the camera strap in (first photo). It is also tall enough that the camera does not make the lid bulge up, but it is snug.There isn't much extra room, however, for any accessories. e.g., the lid is snug enough i wouldn't risk a memory card in the mesh compartment getting crushed against the camera body if the case was banged against something. On second thought, this is a fairly heavy camera, so even if a memory card would fit, I would want the weight of the camera smacking against the cards even if they were in plastic cases.A memory card or two would fit neatly in the space above the camera display (at bottom right of the first photo). A battery might physically fit there BUT would rub against the display and buttons so I wouldn't risk it.Suggestion to Lowepro: make another version of this that is 1/2" wider to accommodate the height of DSLRs (guessing mirrorless cameras are about the same size?). Or better yet, add a full inch to allow room for batteries and memory cards.All-in-all this is perfect for what I want!

Bought this because I have a massive hard case with camera gear, and on work trips when I check my case I like to have my camera on my carry on just incase my case doesn’t show up, or else I can’t do my job. I also wanted to to protect my lense and body a little more rather than they just be thrown into a backpack with other items…the CS80 fits a 24-105 f4 and a canon R7 with a cage perfect. A little snug but not too bad…and I have room for some batteries and sd cards in the top pouch. Good purchase if you want something small to protect your camera on the go or throw inside your backpack.

Rugged case for my old school Canon digital camera. I like that it holds Camera and battery. They've changed the battery chargers so it no longer fits in the case, but that's a small issue.I'm a fan.

Bought this for an Elecraft KX3. Tight fit with radio and accessories, but works well. Provides protection. Fits into my rucksack. Just took it to St Kitts and the radio and equipment was kept perfectly safe and secure.

in 2021 i bought this for 34 bucks. 50 now. wow.