AUDEXEN 3-1/4 Inch Front Led Turn Signal Flat Smoke Lens 1157 Base Amber Lamp Compatible with Harley Motorcycle Road Glide Road King Softail Ultra Classic Ultra Limited Electra Glide

There as described there super bright easy to install and looks great lit up

Excellent item fast change over

I do like the finished look and brightness of the LEDs. Relatively easy to install in spite of necessary manipulation needed to get front lights into housing. In my set of front and rear turn signals, they went ahead and included the resisters. For my 2004 Road King, I definitely needed either resisters or load equalizers because of hyper flashing. But there was NO WAY IN HELL I was gonna use their fire hazard nuclear meltdown cheap-ass resisters!! I already ordered the cool-running Badlands Load Equalizer plug and play module. Don’t get me wrong, these LEDs look awesome, do the job, and are a GREAT value for the $$$. Just be prepared to match them with a quality equalizer to get the results you’re probably expecting.

I wasn’t expecting what I got. It’s relatively cheap, but man is it an awesome set of turn signals. Comes with its own integrated smoked lens, you do not need to retain the original, but you do need the screws. Plugged it in, replaced screws, turned ignition on and immediately noticed the bright white light from these! Thankfully I already have LED headlight and spots on my Ultra Limited. Once I pressed the left signal, switched from white to a flashing amber. Perfect, no lag, and surprise! No hyper-flashing! I bought the box (resistor) to eliminate it, thankfully didn’t bother installing it until I checked the lights first! These are plug-and-play. The amber turn signals are just as bright as the solid white light. These are highly visible. These days with all of the distracted drivers, every little bit of attention grabbing counts. These certainly do their part. Highly recommend these if you have the flat/pancake turn signals (I do only on the front, rear I installed bullets). Highly recommend.

Perfect tight fit on my 2015 Heritage softail classic. I wasn’t sure about the blacked out/smoked lenses but I’m glad I bought them. It gives the motorcycle an updated newer model look. Perfect tight fit, running lights look great because you can see the pattern of the lights thru the cover. Lights are bright but I don’t know how they would compare to higher priced lights. I tried the Harley dealership & after 15 minutes on the phone they only had the rear lights in stock. I ordered these off Amazon and got them the next day. IMPORTANT! You will probably get hyper flash and will have to sync your bike. I followed the instructions on how to synchronize your Harley turn signals. Just do a search online on “how to synchronize your Harley turn signals”I did not need a load stabilizer. Syncing the bike is very easy. I’m satisfied with my purchase.

Nice lights! The sealed system is the way to go instead of an insert with a separate lens route. Easy install and they did work with my deep visor style trim rings. There is about a quarter inch gap at the bottom where it tightens around the sealed lamp assembly, but that doesn’t bother me. I really prefer the look of all the white leds instead of the halo effect, but that’s just my preference.

The set I ordered before this set did not have the one contact for the rear brake and directional bulbs. It had the two contacts which did not work for my 2004 road King so make sure you look to see which style you need before ordering.

Purchased for my Road King. While looking at led headlamp and side light leds I came across a bundle set offered. Included the Headlight side light, brake and tail light and blinker lights all in LED. Everything was plug and play and very simple to swap out. I was thrilled as to the brightness and quality of the forward lamps and the tail and brake led lights. THEY ARE WELL WORTH WHAT I SPENT.... QUALITY,SAFETY, EASE OF INSTALLATION... I could not be happier. Then there were the blinkers..... cheap wiring thin wires, no instructions, sent wrong color from what was ordered and DEFINATELY NOT PLUG AND PLAY LIKE OTHE LIGHTS. I spent 30.00 on electrical resistors to tie into the blinkers to make the voltage correct as they draw much less power. $30.00 shot to hell because that didn't help to solve the problem at all. Even a certified Harley Mechanic who I ride with could not get them to operate and gave me the make and model of the Led blinkers on his Street Glide. Don't Purchase These As they are cheap, not well made, don't work, and caused me hours of of time trying to get them to operate at all !!!!! TOTAL PIECES OF #%@* IN MY OPINON .... BUYER BEWARE !!!!

Awesome lights, easy to install, very attractive and bright. On newer HD models, no need to splice in load resisters or add a module. Do the following: 1; Turn on ignition, without starting 2; Turn on 4 ways. 3; Turn off ignition and let the 4 ways run for 2 minutes. 5; Turn on ignition, without start. 6; Turn off ignition. 7; Turn ignition on and your done.

المنتج جيد ولكن للاسف لم يتتطابق مع الموتر سيكل

They fit perfect, feel and look good. Very bright. If you install them without modifying the circuit (installation of a resistor) then they do the fast flash thing. They did on my 2013 FLHTC. I added the Badlands rear light converter, the one that converts the rear turn signals into running/stop/ turn and this cured the fast flash issue. The only thing is, the convertor is twice the price of the LED lights! The lights and the converter are all worth what they cost.

Fit perfectly, easy to install, functions as expected Should install resistor to stop the hyper flash

Magnifique sur ma Harley et l'éclairage est vraiment visible.