DAYUAN YT1040 Ball Joint Press & U Joint Removal Tool Kit with 4x4 Adapters for Most 2WD and 4WD Cars and Light Trucks,red

Tool has got me out of trouble many times. I had to add a few extra parts for different diameter ball joints but it works great

I bought this kit for self-repair of the suspension from my car. Was impressed with the size of the clamp - in fact, I expected it to be smaller. In general, I am satisfied with this set, because it makes it much easier to work with ball joints.

I purchased this tool with slight scepticism about its ability to do the job of a garage hydraulic press for removal / installation on my 18 yr old original ball joints. Gladly I can report it stood up to the task , however my advice is to have a second pair of hands as it’s a bit of a balance act with the cups right at the start. It’s a substantial build and quite heavy but would recommend to save the garage costs.

Really good heavy duty bit of kit. Had a really stubborn Land Rover axle with ball joints to remove.This held an inch drive beaker bar with scaffold bar on. Tool just worked.

For the price this is a good home mechanic investment, I didn't use it to extract the ball joint and would probably fall back on brute force/big hammer/heat where necessary but pressing in a new part with the receiver cleaned up was easy.

Removing LandRover D4 front and rear upper and lower arms and it has been a horrible job. The rear steering bush screwed me over massively and thought I’d try this tool to release it. It’s a lot cheaper than other sellers and a name I’m not used to.Set it up, did as it said in the instructions and within 30 seconds, the bush was out and I was drinking a brew with a champions grin 😁The tool barely looks used after the immense task. Great buy and an amazing price. Thank you.

It does the job but not the best build quality. One of the mounting bolt’s hadn’t been tapped. Apart from that it works well

Well made