4LIFETIMELINES 3/16" (4.76mm) x 25' - 316L Marine Grade Stainless Steel Brake Line Tubing Coil, Meets SAE Specifications, Universal Compatibility, Brake Line Replacement

Product as described.

Very easy to use and bend, and to double flare

I am using this for 300psi+ CO2 and it works very well with 1/4" SS compression fittings and ferrules.

The media could not be loaded.  I’ll never go back to the rusty steel lines from the auto parts store. This stainless tubing is a bit harder to bend on complex shapes but hold a beautiful flare. You need a decent flaring tool to get the job done. Living by the beach, anything we can install in stainless helps survive the salt air. This is not only functional but also beautiful on its final assembly.

This line is harder to bend and flare than plain steel line but not too difficult if you have the right tool. You only do it once with stainless steel so its worth the extra effort...it should outlast the vehicle. I would not recommend trying to flare stainless steel line with the typical cheap flaring tool. I had one of those once and it broke the flaring disc on soft steel line so it probably wouldn't handle stainless steel well.I use an Eastwood tubing flare tool that clamps in a bench vice and has a long handle that provides the leverage you need. I see Amazon has that tool and a less expensive version by TGR. Excellent tool that makes both 45 degree and bubble flares.

Works well

👍👍

You can bend this line by hand without any special tools. Also if you can get the old fittings off your old lines clean, you could reuse them and then just measure how much line you need, cut with rolling cutter thingy, then double flare the ends of your new stainless line and re-install and add brake fluid and check for leaks!This is great stainless line. It is of very high quality and seems like 316 marine grade stainless, which is perfect for Michigan where the road salt is awful in the winter and rusts out trucks very quickly.Thank you again for supplying this product. God bless.

Awaiting my second selection here to decide if this will work adequately May return. Fast delivery..

Made all new brake lines for my restomod C10 build using this line.Chose to do single flare with appropriate fittings, have had no leaks over 2 years.Using a bender this line bends very well, can also be bent by hand if you know what you’re doing.

Met published specifications.

Great product.... replaced brake lines on large boat trailer.... worked out great

Still looks brand new after two full salty winters in here in Canada! Product and fittings are good quality. A bit of advice: Flare your ends in a bench vise before routing lines in the vehicle because it is slightly harder to flare!